|
Hello again -- I once again do not see firmware for this oscilloscope on the page. Only windows software and windows driver.
Is there an update after 160630.0? The trigger issue is frustrating; adjusting trigger is buggy when in "normal" mode.
e.g. if input signal is 1V P-P and trigger is at 3V with normal settting, naturally there is no trigger (trigger threshold is too high). However, rotating trigger level dial slowly to reduce trigger voltage does not work. You must rotate dial quickly which leads to big jumps in trigger level. It is impossible to adjust slowly and carefully.
Also, I see no way to adjust horizontal probe offset/skew (i.e. connect ch1,2,3,4 to cal input, each channel will be offset from others a little bit, most scopes have a way to adjust each channel left/right to line them all up so they are exact. LA also has no way to correct skew with analog scope inputs.
|
|