Electronic Engineer Discuss

View: 10427|Reply: 0
Print Prev. thread Next thread

Hantek Handheld Spectrum Analyzer - HSA2000 Series

[Copy link]

17

Threads

20

Posts

83

Credits

注册会员

Rank: 2

Credits
83
Jump to specified page
1#
Post time 2016-1-25 08:46:04 | Show the author posts only Reply Awards |Descending |Read mode
Frequency range :9KHz~3.2GHz;
Optimal sensitivity: -161dBm;
Built-in 3.2GHz tracking generator(TG)
FM/AM audio demodulator, frequency counter;
Firmware free lifetime upgrades
Offers 7800mAh 18650 rechargeable battery pack for continuously working up to 4 Hours;

Features

  • Frequency range: 9KHz-3.2GHz (tunable to 9KHz) AC Coupled
  • Optimal sensitivity: -161dBm
  • HSA2000 Series spectrum analyzer has the lowest DANL and SSB phase noise, and narrowest RBW. It greatly enhances the recognition ability to the spurious signal and noise signal.
  • Optional FM/AM modulation analysis, including carrier power, modulation rate, AM depth/FM deviation, SINAD and carrier frequency offset.
  • Standard spectrum feature. It can analyze the signal time stability, and find out lacunar signal in communication system accurately.
  • Strong field strength test function, fit for the test work in transmitter, base station and the antenna coverage site. It can show the density of field strength or power. The user could also calibrate gain or loss by using amplitude offset function.
  • HAS2000 Series has least RBW in the same level of analyzers, and can easily confirm, distinguish and measure two similar signals.
  • The 5.7 inch highlight color display can provide accurate, bright and clear trace both inside and outside, no need to move to shading place for work.
  • Short scanning time. It can fast catch the data and help to locate and recognize the irregular transient disturbance signal, and then optimize the testing time and accuracy.
  • Advanced built-in battery management system is adopted. Standard super large capacity-7800mAh lithium battery, and support 6 packs of 18650 battery pack which can keep measurement working in site for over 4 hours.
  • Firm and tight mechanical structure, close rubber sleeve pack, which is fit for harsh site work environment.
  • Integration USB Host & Device, support USB flash disk memory, optional WIFI/LAN, which is convenient for networking and long-range control.
  • Its PC software can achieve the management and storage of testing data.
  • HSA2000 Series site measurement application.
  • Aerospace and Defense: Radio and Radar, interferometric analysis, site repairment.
  • Wireless service provider: interferometric analysis, site repairmen.
  • TV & Radio: interferometric analysis, check of channel power.
  • Spectrum management agency: spectrum monitor.

Parameters
Model
HSA2030A
HSA2030B
Frequency
Frequency Range
9KHz~3.2GHz AC Coupled
9KHz~3.2GHz AC Coupled 5M~3.2GHz TG
Frequency Resolution
1Hz
Reference Frequency
10MHz
Frequency Readout Accuracy
±(frequency indication*frequency reference uncertainty+1%*span+20%RBW+marker resolution+1Hz)
Internal 10MHz Reference
Accuracy
Aging rate
±1ppm/year(0℃~50℃,Reference is 25℃)
Temperature stability
±1ppm/year
Marker Resolution
(Frequency span)/(number of sweep points-1)
Resolution Bandwidth(RBW)
-3dB Bandwidth
10Hz to 1MHz,1-3-10 sequence
Accuracy
±5%  RBW=10Hz~1MHz nominal
Resolution Filter Shape Factor
<5:1 nominal
Video Bandwidth(VBW)
-3dB bandwidth
1Hz to 1MHz,1-3-10 sequence
Accuracy
±10% VBM=1Hz~1MHz nominal
Displayed Average Noise Level (normalized to1Hz)
9K~1MHz
Preamp off
-108dBm,typical -127dBm
1MHz ~10MHz
-128dBm,typical -146dBm
10MHz ~500MHz
-142dBm,typical -146dBm
500MHz ~2.5GHz
-141dBm,typical -145dBm
2.5GHz ~3.2GHz
-140dBm,typical -144dBm
9K~1MHz
Preamp on
-131dBm,typical -150dBm
1MHz ~10MHz
-148dBm,typical -163dBm
10MHz ~500MHz
-161dBm,typical -164dBm
500MHz ~2.5GHz
-159dBm,typical -162dBm
2.5GHz ~3.2GHz
-158dBm,typical -161dBm
SSB Phase Noise
Carrier Offset(20℃~
30℃,500MHz
Central Frequency)
10K
< -92 dBc/Hz, typical -95 dBc/Hz
30K
< -93 dBc/Hz, typical -96 dBc/Hz
100K
< -95 dBc/Hz, typical -97 dBc/Hz
1MHz
< -117 dBc/Hz, typical -119 dBc/Hz
Sweep Time
Range
Span >100Hz
2ms to 1000s
Span=0Hz
600ns to 200s
Sweep Mode
Continuous, single
Trigger Source
Free run; video; external
Trigger slope
Selectable positive or negative edge
Trigger delay
Span =0Hz
±12ms to ±12s nominal
Frequency Counter
Counter Resolution
1Hz
Accuracy
± (marker frequency × frequency reference uncertainty + counter resolution)
Level Display Range
Log Scale and Units
1 to 10 dB/divisions in 1, 2, 5, 10 dB steps, 10 divisions displayed
Linear Scale and Units
0 to 100%,10 divisions displayed
Scale Unit
dBm,dBmV,dBuV,Watts,Volts
Sweep (Trace) Points
461
Number of Markers
4
Detectors
Normal, positive peak, dample, negative peak, RMS
Number of Traces
4
Trace Functions
Clear/write, maximum hold, minimum hold, average, check,close
Level Measurement Error
±1.5dB(excluding input VSWR mismatch)  
20~30℃,peak detector, preamplifier off, input signal -50dBm to 0dBm
Reference Level
Setting Range
-100dBm to +30dBm, steps of 1dB
Setting Resolution
Log scale
0.01dB
Linear scale
Almost log(2.236μV to 7.07V)
Amplitude
Maximum Safety Input Level
Average continuous power
+33dBm
DC input voltage
50Vdc
Measurement Range
9KHz~2MHz
Displayed average noise level (DANL) to +10dB
2MHz~3.2GHz
Displayed average noise level (DANL) to +20dB
Input attenuator range
0 to 51dB,1dB steps
Spurious Response
Second Harmonic Distortion(SHI)
<65dBc,50MHz to 3GHz(Mixer level -30dBm,attenuator =0dB,preamp off,20℃~30℃)
Third-Order
Intermodulation(TOI)
50~300MHz
+8dBm,Third-order intermodulation products:2 x -20dBm; frequency separation 100KHz:attenuation = 0dB; preamp off,20℃~30℃
300MHz~3.2GHz
+10dBm
Input Related Spurious
<-75dBc,(input mixer = -30dBm)
Inherent Residual Response
<-90dBm,typical -98dBm (Input terminated and 0 dB RF attenuation, preamplifier off)
RF Input VSWR
(at Tuned Frequency)
10MHz to 3.2GHz
<1.5:1, nominal         Attenuator setting 10~20dB
10MHz Reference/External Trigger Input
Reference Iinput Frequency
10MHz
Reference Input Amplitude
0~10dBm
Trigger Voltage
5V TTL level
Connector and Output Impendence
N female;(50Ω)
Gennral Feature
Interface Language
English,Chinese,Chinese Traditional
Display Index
5.7 inch,640*480 resolution,64M color LCD display
Temperature Range
Working
-10℃ to +50℃,(battery:0℃ to 50℃)
Storage
-40℃ to +70℃,(battery :-20℃ to 50℃)
Relative Humidity
<95%
Weight
2.9kg(with battery),2.6kg(without battery)
Size
260m X 220m X 75m
Power
Input voltage range
DC: 12-17V, maximum 2.8A input  220VAC±15%
AC frequency range
40Hz to 60Hz
Power consumption
Maximum 32W




This post contains more resources

You have to Login for download or view attachment(s). No Account? Register

x
Reply

Use magic Report

You have to log in before you can reply Login | Register

Points Rules

Dark room|Mobile|Archiver|Electronic Engineer Discuss

2024-4-20 11:07 GMT+8 , Processed in 0.175693 second(s), 21 queries .

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

Quick Reply To Top Return to the list