Title: Hanteck 1008C USB nor recognized [Print this page] Author: aconsuegra Time: 2017-9-10 23:31 Title: Hanteck 1008C USB nor recognized Hi, i have this usb scope. It was working but suddenly it is no longer recognized when connected to any USB port.
It is not a drivers issue, but a physical problem. The unit is powered and led goes green, but no device is shown in devices manager.
I have tested the 3,3 regulator (ok) and i suspect the usb port of MCU stm32f103c8t6 is faulty.
Is it possible to get binaries to replace the bad chip?
Thanks
Author: amy Time: 2017-9-12 16:59
Sir, I have replyed you via email, please check.
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)