Title: dso2090 oscilloscope [Print this page] Author: Antonio.C Time: 2017-7-8 15:01 Title: dso2090 oscilloscope hi,
I bought with you an oscilloscope hantek dso 2090 usb, the same arrived missing the manual and the cd is empty.
I downloaded the software through the site, I did the installation, but windows does not recognize the equipment. I installed the drive manually, but it still does not recover.
The LED does not work, even with everything installed.
how should I proceed.
I waited two months for the device to arrive, and I Unfortunate surprise
Regards,
Author: amy Time: 2017-7-8 15:27
Sir, the driver is not installed successfully.
And update the driver manually. Author: Antonio.C Time: 2017-7-8 23:18
Hello all well
I installed the software and plugged the oscilloscope into the usb port, but windows did not recognize the device, so I installed the drive manually but it still does not recognize it.
My pc is an amd phenon ii x3 system
Windows 7 professional 64-bit operating system.
Obs. When I plugged the device into the usb ports, the led should not light up?
Antonio Carlos
This is the message from windows
A device connected to usb has malfunctioned and windows does not recognize
In the device manager appears as unknown device, and under Properties it displays the following message:
Windows stopped this device because it encountered problems. (Code 43) Author: amy Time: 2017-7-11 09:03
Sir, please right click a .sys file in the driver folder and open the properties. Select "digital signatures" and upload a screenshot as the following picture.
[attach]1629[/attach]
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)