Title: DSO 8060 Output Arbitrary Waveform Steps [Print this page] Author: WisdomAugust Time: 2015-7-18 14:53 Title: DSO 8060 Output Arbitrary Waveform Steps 1. Turn on DSO8060.
2. Switch DSO to signal source status.
3. Connect DSO to PC by a USB cable.
4. Open the software on PC.
5. Click [attach]44[/attach] in the menu to open a signal source operation window. See below picture.
[attach]45[/attach]
6. Press [attach]46[/attach]in the toolbar of signal source window to open following device option window.
[attach]47[/attach]
7. Select the device you want to open and click “OK”.
8. Click [attach]48[/attach] in the signal source window toolbar to connect DSO to PC.
9. Click [attach]49[/attach]in toolboor to enter into the arbitrary waveform edition interface.
10. Zoom in/out the editable waveforms by clicking [attach]50[/attach] button.
11. Dragging the editable waveforms by press mouse left constantly.
[attach]51[/attach]
12. Output the signals to other oscilloscope by a BNC connecting cable, and you can observe the same waveforms on the other oscilloscope.
[attach]52[/attach]
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)