Electronic Engineer Discuss

Title: Hantek Handheld Spectrum Analyzer - HSA2000 Series [Print this page]
Author: Tina    Time: 2016-1-25 08:46
Title: Hantek Handheld Spectrum Analyzer - HSA2000 Series
Frequency range :9KHz~3.2GHz；
Optimal sensitivity: -161dBm；
Built-in 3.2GHz tracking generator(TG)
FM/AM audio demodulator, frequency counter;
Firmware free lifetime upgrades
Offers 7800mAh 18650 rechargeable battery pack for continuously working up to 4 Hours;

Features

  • Aerospace and Defense: Radio and Radar, interferometric analysis, site repairment.
  • Wireless service provider: interferometric analysis, site repairmen.
  • TV & Radio: interferometric analysis, check of channel power.
  • Spectrum management agency: spectrum monitor.

Parameters
Model
HSA2030A
HSA2030B
Frequency
Frequency Range
9KHz~3.2GHz AC Coupled
9KHz~3.2GHz AC Coupled 5M~3.2GHz TG
Frequency Resolution
1Hz
Reference Frequency
10MHz
Frequency Readout Accuracy
±(frequency indication*frequency reference uncertainty+1%*span+20%RBW+marker resolution+1Hz)
Internal 10MHz Reference
Accuracy
Aging rate
±1ppm/year（0℃~50℃，Reference is 25℃）
Temperature stability
±1ppm/year
Marker Resolution
(Frequency span)/(number of sweep points-1)
Resolution Bandwidth（RBW）
-3dB Bandwidth
10Hz to 1MHz，1-3-10 sequence
Accuracy
±5%  RBW=10Hz~1MHz nominal
Resolution Filter Shape Factor
＜5:1 nominal
Video Bandwidth（VBW）
-3dB bandwidth
1Hz to 1MHz，1-3-10 sequence
Accuracy
±10% VBM=1Hz~1MHz nominal
Displayed Average Noise Level (normalized to1Hz)
9K~1MHz
Preamp off
-108dBm，typical -127dBm
1MHz ~10MHz
-128dBm，typical -146dBm
10MHz ~500MHz
-142dBm，typical -146dBm
500MHz ~2.5GHz
-141dBm，typical -145dBm
2.5GHz ~3.2GHz
-140dBm，typical -144dBm
9K~1MHz
Preamp on
-131dBm，typical -150dBm
1MHz ~10MHz
-148dBm，typical -163dBm
10MHz ~500MHz
-161dBm，typical -164dBm
500MHz ~2.5GHz
-159dBm，typical -162dBm
2.5GHz ~3.2GHz
-158dBm，typical -161dBm
SSB Phase Noise
Carrier Offset(20℃~
30℃，500MHz
Central Frequency）
10K
< -92 dBc/Hz, typical -95 dBc/Hz
30K
< -93 dBc/Hz, typical -96 dBc/Hz
100K
< -95 dBc/Hz, typical -97 dBc/Hz
1MHz
< -117 dBc/Hz, typical -119 dBc/Hz
Sweep Time
Range
Span >100Hz
2ms to 1000s
Span=0Hz
600ns to 200s
Sweep Mode
Continuous, single
Trigger Source
Free run; video; external
Trigger slope
Selectable positive or negative edge
Trigger delay
Span =0Hz
±12ms to ±12s nominal
Frequency Counter
Counter Resolution
1Hz
Accuracy
± (marker frequency × frequency reference uncertainty + counter resolution)
Level Display Range
Log Scale and Units
1 to 10 dB/divisions in 1, 2, 5, 10 dB steps, 10 divisions displayed
Linear Scale and Units
0 to 100%，10 divisions displayed
Scale Unit
dBm，dBmV,dBuV,Watts，Volts
Sweep (Trace) Points
461
Number of Markers
4
Detectors
Normal, positive peak, dample, negative peak, RMS
Number of Traces
4
Trace Functions
Clear/write, maximum hold, minimum hold, average, check，close
Level Measurement Error
±1.5dB(excluding input VSWR mismatch)  
20~30℃，peak detector, preamplifier off, input signal -50dBm to 0dBm
Reference Level
Setting Range
-100dBm to +30dBm, steps of 1dB
Setting Resolution
Log scale
0.01dB
Linear scale
Almost log（2.236μV to 7.07V）
Amplitude
Maximum Safety Input Level
Average continuous power
+33dBm
DC input voltage
50Vdc
Measurement Range
9KHz~2MHz
Displayed average noise level (DANL) to +10dB
2MHz~3.2GHz
Displayed average noise level (DANL) to +20dB
Input attenuator range
0 to 51dB,1dB steps
Spurious Response
Second Harmonic Distortion（SHI）
<65dBc，50MHz to 3GHz（Mixer level -30dBm，attenuator =0dB，preamp off，20℃~30℃）
Third-Order
Intermodulation（TOI）
50~300MHz
+8dBm，Third-order intermodulation products：2 x -20dBm; frequency separation 100KHz：attenuation = 0dB; preamp off，20℃~30℃
300MHz~3.2GHz
+10dBm
Input Related Spurious
<-75dBc，(input mixer = -30dBm)
Inherent Residual Response
<-90dBm，typical -98dBm (Input terminated and 0 dB RF attenuation, preamplifier off)
RF Input VSWR
(at Tuned Frequency)
10MHz to 3.2GHz
＜1.5:1, nominal         Attenuator setting 10~20dB
10MHz Reference/External Trigger Input
Reference Iinput Frequency
10MHz
Reference Input Amplitude
0~10dBm
Trigger Voltage
5V TTL level
Connector and Output Impendence
N female；（50Ω）
Gennral Feature
Interface Language
English，Chinese，Chinese Traditional
Display Index
5.7 inch，640*480 resolution，64M color LCD display
Temperature Range
Working
-10℃ to +50℃，（battery：0℃ to 50℃）
Storage
-40℃ to +70℃，（battery :-20℃ to 50℃）
Relative Humidity
<95%
Weight
2.9kg（with battery），2.6kg（without battery）
Size
260m X 220m X 75m
Power
Input voltage range
DC: 12-17V, maximum 2.8A input  220VAC±15%
AC frequency range
40Hz to 60Hz
Power consumption
Maximum 32W








Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/) Powered by Discuz! X3.2