①Stock the firmware file into a memory stick→②Start up device→③Plug the memory stick on the device→④Push the UTILITY button→⑤Click F5 button to turn the page to 4/4, then press F3 button to do update→⑥Using the up&dwon button to choose the correct firmware file→⑦Press ENTER button to do update→⑧Restart device automatically when updating finish.
Update procedure:
1. Stock the firmware file into a memory stick.
2. Start up device by push the yellow power button at the left bottom of the device keyboard. The device screen will appear start up interface.
[attach]172[/attach]
Handheld Oscilloscope Start Up Interface
Waiting for a second, the device enters into working interface as follows:
[attach]173[/attach]
3. Plug the memory stick into the USB port on the right side of the device.
[attach]174[/attach]
4. Push the UTILITY button on the keyboard.
[attach]175[/attach]
5. Click F5 button to turn the page to 4/4. And then press F3 button to do update.
[attach]176[/attach]
6. Using the up&dwon button to choose the correct firmware file at following interface.
[attach]177[/attach]
7. Press ENTER button to update the firmware. Device will appear following update interface.
[attach]178[/attach]
8. Device restarts automatically when updating finished.
[attach]179[/attach]
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)