Title: DSO 5102p insensitive to signal and self cal failed at 2/32 [Print this page] Author: vineesh Time: 2023-10-23 02:16 Title: DSO 5102p insensitive to signal and self cal failed at 2/32 hi.. I have an issue with my hantek DSO 5102p. My DSO was working fine but suddenly it became insensitive to any signal. DSO shows only a straight line ( For both Channels)
I updated the firmware but nothing changed, also i tried for self calibration , it stops at 2/38.
i have noticed one thing that is , none of the relays inside the device are working, Befor the DSO had this problem, i could hear the relay inside working when it was switched ON.
please give me a solution ...
Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)