Cursors Key -> Mode Softkey help information Press this softkey to toggle the cursors mode between manual and track. Manual - X, Y, X-Y, 1/dX values are displayed. Adjust cursor positions by rotating the V0 knob. Track - When you turn the V0 knob, as the X cursor moves, the corresponding Y cursor follows the waveform assigned to the X source.
Cursors Key -> Mode Manual -> Source Softkey help information Select the analog channel or math as the source on which the cursors will indicate measurements.
Cursors Key -> Mode Manual -> Y Softkey help information Select the Y cursors, and use the V0 knob to adjust its position. Y cursors are horizontal dashed lines that adjust vertically and normally indicate Volts. When math functions are used as a source, the measurement units correspond to that math function.
Cursors Key -> Mode Manual -> X Softkey help information Select the X cursors, and use the V0 knob to adjust its position. X cursors are vertical dashed lines that adjust horizontally and normally indicate time relative to the trigger point. When used with the FFT math function as a source, the X cursors indicate frequency.
Cursors Key -> Mode Manual -> X-Y Softkey help information Select the X-Y cursors mode. Push the V0 knob to change the selected cursor, and rotate the V0 knob to adjust the position.
|