Hantek 2D72 - crash during fw upgrade
Customer Consultation:Dear Hantek-team,
I tried to flash a new firmware version on a 2D72 I recently received,
serial CN21060072051958. Sadly, as I selected "start" in the DfuSeDemo
software, the application hung and stopped doing anything after showing
"erasing flash (0%)". I let this run anyway for about 12 hours before trying
to restart the process, and in the end, restarting the computer. Now, the
oscilloscope does not boot any longer and does not go into DFU mode, it just
seems bricked. Is there any way to revive the device?
Reply:
Please try to program ARM1.
Hi
I have a 2D42 and I happened exactly the same, would I also use the arm1 for this model?
Thanks
kirko replied at 2022-4-9 00:53
Hi
I have a 2D42 and I happened exactly the same, would I also use the arm1 for this model?
Yes. The same program.
Edited by KAKEGYJE at 2022-12-8 09:15
Hola!, soy nuevo en el foro, tengo un 2D72, el cual después de muchos intentos fallidos de recuperarlo, por fin logre hacerlo, pero tengo un gran problema, ya no me muestra el Número de serie y en modelo me pone 2Dxx, por lo que la función de osciloscopio no funciona, sabe alguien como corregir esto?.
en donde puedo ver u obtener mi número de serie y como inyectarlo nuevamente?
Hello, I am new to the forum, I have a 2D72, which after many failed attempts to recover it, I finally managed to do it, but I have a big problem, it no longer shows me the Serial Number and in the model it puts me 2Dxx, for what the oscilloscope function does not work, does anyone know how to correct this?.
where can i see or get my serial number and how to inject it again?
Edited by KAKEGYJE at 2022-12-8 09:16
ying replied at 2022-4-15 09:13
Yes. The same program.
Ok, thank you, it has served me, I have managed to recover the boot loader.
Pages:
[1]