Krot Publish time 2020-8-10 22:19:29

Hantek DSO1060 after rolling back the firmware does not load

Hello, please help, while my oscilloscope Hantek DSO1060 has been rolled back firmware, on the screen appeared the message "ROLL BACK" with the progress bar on the oscilloscope worked fine after I turned it off and then turned on the oscilloscope can not boot, now when you button it emits a beep and turns off 5 seconds, for repair need a flash memory dump.

amy Publish time 2020-8-15 09:30:57

Sorry, the factory waveform is only for demonstration, so we don’t have the function of loading it.

Krot Publish time 2020-8-16 23:07:02

To repair it you need to flash the flash memory dump (SST39VF3201),I need a binary file firmware dump, I'll flash it into memory and my oscilloscope will work.

amy Publish time 2020-8-17 16:09:53

Sorry, my last reply was wrong. We can provide the .hpc file, if you can flash it yourself, please email me. caiyijun@hantek.com

Krot Publish time 2020-8-18 22:27:36

Hello, I answered your email

Krot Publish time 2020-8-27 00:45:19

You misunderstood me, the oscilloscope does not load, I need a dump of the flash memory chip (SST39VF3201), and what you sent me is a file for updating via USB flash drive, I have the same as here https://www.eediscuss.com/forum.php?mod=viewthread&tid=8455&extra=page%3D1 only the oscilloscope model is different.

Krot Publish time 2020-10-31 22:05:23

The problem is not solved, you need a flash dump SST39VF3201

zik.67@mail.ru Publish time 2020-11-19 12:51:10

zik.67@mail.ru

Krot Publish time 2020-12-10 17:06:26


The problem is not solved, you need a flash dump SST39VF3201:'(

vintolet Publish time 2023-11-15 14:41:46

Есть дамп в наличии
Pages: [1]
View full version: Hantek DSO1060 after rolling back the firmware does not load