Hantek HT25 COP probe setting in software
There is no HT25 COP probe setting in the 1000C software that i have, also do you use an attenuator with the probe or is it built into the probe?The attenuation ratio of HT25 is 10000:1, just select X10000 in the software.
wangshuang replied at 2020-6-9 15:48
The attenuation ratio of HT25 is 10000:1, just select X10000 in the software.
Thank you for the reply, are there any videos on using the COP probe?
You can refer to the picture in Hantek website,
http://hantek.com/ProductDetail_18_6229.html
or view on this link:
https://www.iqiyi.com/w_19rssgnkf1.html
Pages:
[1]