QMESAR Publish time 2020-4-16 19:48:19

1008C All input channels show max 1V

Edited by QMESAR at 2020-4-16 19:49

Hi Team

I am so sad I love my 1008C scope ,Yesterday I worked with it in an area where there were a lot of ESD running even my PC stopped (freezed some times)
the result of this is my scope is now broken all the channels can only show max 1V mexample I apply 5V DC to channel 1 with probe set at x1 I see only 1 V
if I connect the probe to the calibration points which should be 2Vp-p I get a 500mV p-p signal
Can you tell me if it is possible to repair the scope ? Can I test some componets to track the broken commponent

I appreciate any help

Regards




amy Publish time 2020-4-17 10:50:01

It's not easy to judge the specific problem.
Please contact your seller to return factor for repair.

QMESAR Publish time 2020-4-17 12:56:10

Hi.
To return it for repair will cost the same a new one,
I just ordered a new one thanks
Pages: [1]
View full version: 1008C All input channels show max 1V