Sapp Publish time 2020-1-26 19:50:07

Problem with new Hantek 2D82

Edited by Sapp at 2020-1-26 20:56

Hello, i bought a new Hantek 2D82Auto and get it yesterday.After a short view to funktions suddenly the normal english words on display changed to anything not readable . So have a look tot he picture. Then i want connect the device to my notebook to check the connection with the hantek software and or look for a new firmware, but my computer do not found any device. And if i tryto start the device with an a usb cable connectet the device will not start.




Sapp Publish time 2020-1-27 01:53:34

Ok, now i was in able to start the update mode without batteries and update the 2d82 and it looks like everything in fine now. Hope it keeps so


dgtall Publish time 2020-2-6 02:32:47

Sapp replied at 2020-1-27 01:53
Ok, now i was in able to start the update mode without batteries and update the 2d82 and it looks li ...

same problem , can you help me please with the update procedure

Sapp Publish time 2020-2-11 01:53:55

You should download all tools and software for the item. Then install the software and read all the informations to do the update. Especially you have to take out the batterys bevor start the update. In my case only an old Tinkpad T400 detected the Hantek on usb port.

amy Publish time 2020-2-14 16:56:38

dgtall replied at 2020-2-6 02:32
same problem , can you help me please with the update procedure

Connect the scope to your computer and click About->CheckUpdate, and follow the prompts to operate.


Pages: [1]
View full version: Problem with new Hantek 2D82