How to Use the Burst Function of HDG6000B?
How to Use the Burst Function of HDG6000B? HDG6000B can output a waveform for a specified number of cycles, called a burst.To Output a Burst You can output the burst at a rate determined by the internal rate generator or the signal level on the front-panel Sync/Mod/Trig connector. For this example, you will output a three-cycle sine wave with a 10 ms burst period. You will not change the other parameters from their default settings: internal burst source and 0 degree starting phase.
Edited by WisdomAugust at 2019-7-11 08:04
1 Select the function and amplitude of the burst. For burst waveforms, you can select sine, square, ramp, pulse, or arbitrary waveforms (noise is allowed only in the “gated” burst mode and dc is not allowed). For this example, select a sine wave with an amplitude of 200mV.
2 Select the burst mode.
Press and then verify that the “N Cycle” (internally-triggered) mode is currently selected.file:///C:\Users\ADMINI~1\AppData\Local\Temp\ksohtml5012\wps1.jpg
3 Set the burst count. Press the countsoftkey and then set the count to “3” using the numeric keypad or knob.
4 Set the burst period. Press the period softkey and then set the period to 10 ms using the numeric keypad or the knob and cursor keys. The burst period sets the time from the start of one burst to the start of the next burst.
At this point, the function generator outputs a continuous three-cycle burst (if the output is enabled).
5 View the waveform. To view the waveform parameters.
Note: A. You can generate a single burst (with the specified count) by pressing the Trigger key.B. You can also use an external gate signal to either turn the burst signal “on” or “off” based on the external signal applied to the front-panel Sync/Mod/Trig connector.
To Trigger a Burst You can issue triggers from the front panel for bursts using a manual trigger or an internal trigger. ? Internal triggering is enabled with the default settings of the function generator. In this mode, the function generator outputs continuously when the burst mode is selected. ? Manual triggering initiates one burst each time you press theTrigger key from the front-panel. Continue pressing this key to re-trigger the function generator. Generator display when using a manual trigger
Oscillscope display when using a manual trigger
? The Trigger key is disabled when a function other than burst is currently selected (or when the output is disabled). A message
pop up in display when using a manual trigger.
Burst Mode You can configure the function generator to output a waveform with a specified number of cycles, called a burst. The function generator can produce a burst using sine, square, ramp, pulse, harmonic or arbitrary waveforms (noise is allowed only in the gated burst mode and dc is not allowed). Produce a burst using sine.
The Sine key light when using sine wave.
Burst display on the generator when using sine wave.
Display on the oscilloscope when using sine wave.
Produce a burst using square.
The Square key light when using a square wave.
Burst display on the generator when using square wave.
Display on an oscilloscope when using square wave.