How to use the Digital Generator on the waveform generator of HDG6000B?
Review the Output Terminal Signal Output Terminal Under Device Display
Output Terminal On Digital Generator Interface
Terminal Description
Note: Vcc: 3.3V
Edited by WisdomAugust at 2019-6-13 13:11
Press Data Output key to enable digital generator function.The backlight of the key become light in yellow.
The digital generator interface is opened and output the signal at the same time.
Digital Generator Interface
Signal Display on Logic Analyzer
Press Function softkey to set the function as sync signal, programmable signal and turn off function.
When select function as Sync, the digital generator output synchronized signal of CH1 or CH2.
When select the sync signal source to CH1
When select the sync signal source to CH2
Open CH1 waveform output, Select the Signal Type to "Sine ", frequency to “1KHz”, Amplitude to 1V, Y Offset to 0V.
Connect Digital Generator Terminals to LOGIC Analyzer Terminals to measure. The output signal of D0-D15 terminals is a square waveform (3.3V, peak- to- peak).
Programmable Signal Select function to Prog, use the direction keys and knob to modify the value for D0~D15 to 0 or 1.
Programmable Signal: Users can edit digital signal.
The corresponding terminals will output high level or low level. When the data is set to 0, the corresponding output voltage is 0V. When the data is set to 1, the corresponding output voltage is 3.3V. Such as, D0~D7: 10101010, D8~D15: 01010101, in the figure below. Programmable Signal D0~D7: 10101010, D8~D15: 01010101 Display on Generator
Programmable Signal D0~D7: 10101010, D8~D15: 01010101 Display on Logic Analyzer
Pages:
[1]