Good afternoon. Why 2D42 capacitors measures only up to 10 mk.f
Hello. Thank you very much that in the new firmware for February they implemented the function of at least m maximum. The device works better with this firmware.
Hi
I have just updated to the latest firmware, I have 2 issues that are bothering me
1, Why is the Autoranging on DMM, OHMof this multimeter is so SLOW??
2, would greate if the backlight timeout would reset itself when the meter is being used on DMM ( when input is detected)
Is it possible to resolve these issues?
Thanks
Hi
I have a new problem after upgrading the firmware I lost the AWG function meter is being detected as 2C42!!when it should be 2D42
How can I resolve this Please help
Последняя прошивка HantekHTX2019010401 с ошибкой. AWG не работает или работает через раз. Сам осциллографне видит сигнал от генератора.
Alan_C replied at 2019-2-26 02:21
Hi
I have a new problem after upgrading the firmware I lost the AWG function meter is being detecte ...
Sir, before update the firmware, have you used the AWG interface to output the signal?
Can you confirm that the model in the system information is 2D72 before you update the firmware?
Edited by Alan_C at 2019-2-26 16:31
Hi ,
Yes I have used the AWG before you can see in the picture the model number
and the firmware model number does not match !!Meter Serial No: CN1848008001214
How can I fix this Problem Please Help ??
dreamich replied at 2019-2-26 11:17
Последняя прошивка HantekHTX2019010401 с ошибкой. AWG не работает ...
I have on model 2D42 all works. To see the oscilloscope signal from the generator, you need to run it by pressing the button it will change from red to green, then if you close the probes and select the Scope function, you can see the signal. The mass during the test can not be connected
Alan_C replied at 2019-2-26 16:18
How can I fix this Problem Please Help ??
Try to reset the settings and install the firmware Hantek2000_Firmware2018120601 without connecting anything except the cable to the computer